The Chirp Signal for the Shiva Neural System

The Shiva Neural Stimulation Software
ONLINE SOFTWARE DEMO ◊  CLICK IMAGES TO VIEW CLOSE-UP.

Not all functions perform online – this demo is here so you can learn how it works.  It can’t be used to run actual sessions.
Legal: Shiva signals are based on templates licensed by Stan Koren and Dr. Michael A. Persinger.
Modulated 40 Hertz “Chirp” Signal.

HOME


THE SCIENCE

UNDERSTANDING THE PRINCIPLES

HOW SHIVA WORKS
UNDERSTANDING PSYCHIC SKILLS
SUPPORTING RESEARCH

PSYCHIC SKILLS & ALTERED STATES
SHIVA AND ALTERED STATES
UNDERSTANDING THE NEUROSCIENCE OF  PSYCHIC SKILLS
HEALING SKILLS
PRAYER

ACCESS SESSIONS
USED IN EXPERIMENTS
SIMPLE SIGNALS

SESSION DESIGN
HOW TO PLACE THE MAGNETIC COILS
SESSION LENGTHS & SCHEDULES
MAXIMIZING THE SESSIONS
SAFETY

SETTING UP SHIVA
SET UP YOUR HARDWARE (1)
SET UP THE SOFTWARE (2)
CONNECTING THE COILS (3)
PUTTING ON THE COILS (4)
TECH SUPPORT
SETTING YOUR VOLUME
SAFETY
CONSUMER INFORMATION
SHIVA WITH LAPTOPS
SHIVA WITH DESKTOPS
SETUP FOR AN 8 COIL SHAKTI
PROBLEMS

ABOUT

END-USER LICENSE
CREDITS
UPDATE
SOFTWARE
UNLOCK SOFTWARE
ORDER SHIVA

 

 

This is one of the most important signals in the Shiva Software.

Its based on two principles. One, that a modulated 40 hertz signal is effective for eliciting altered states, due to it’s interaction with the brain’s “binding factor” (learn more), and two, that the greater the variation in a signal, the harder it is for the brain to habituate to it – or ‘tune it out’.

The scientific literature about complex magnetic signals contains many references to a signal “tailored from a ‘chirp sequence'” with frequency modulations in the very low frequency range. One example of such a signal has referred to as a ‘pulse’ named for it’s designer in the literature, but it was developed without being able to use the the modulated 40 hertz signal which had not been developed at the time.

This isn’t a ‘structure-specific’ signal. It doesn’t ‘target’ any one specific brain part. Rather, it targets a specific brain function – maintaining conscious awareness in normal states of consciousness. The modulated 40 hertz signal can alter consciousness in such a way that altered states are much more likely.

One of it’s features is seen in how another ‘chirp’ signal was used as part of two-phase sessions. These sessions were used in a series of experiments that later proved to be the most effective in reproducing “paranormal experiences”. These consisted of a modified ‘chirp’ signal over the right side followed by the amygdala signal over both sides. Each phase lasted 30 minutes for a total of one hour.

The modulated 40 hertz chirp signal is best used as part of sessions with multiple phases. It is suggested that you not use it by itself (as presented here) until after you have used Shiva in other ways.

When beginning to use any signal, it’s a good idea to begin with shorter sessions.

A classical “Chirp” signal. Notice how the frequency gets lower as the signal progresses.

20 Minute 40 Hertz Chirp Session

30 Minute 40 Hertz Chirp Session

60 Minute 40 Hertz Chirp Session

♦♦♦
ORDER SHIVA
Contact us via Web form

In the USA, you can order by calling 24/7  (Toll-Free)
(855) 408-7888
Read the Terms and Conditions before you call.